|
GO TO PAGE 2.....
|
W4BSB .... Radio TX/AMP Items For Sale TO LICENSED OPERATORS ONLY (757) 651-1316 Cell W4BSB@rkhub51.net
Any questions or concerns please send Email to: W4BSB |
|
|
|
I am NOT a dealer so all items offered here are from my personal collection of Ham and other Radio gear. These items have become excess to my needs as I move foward in amateur radio. Only offers from the US and Canada will be considered. I prefer payment by Cash or PayPal, United States Post Office Money order or a cashiers check made out to me for the exact amount from a US bank or approved Canadian money sources.
|
|
|
|
Item: $425 + shipping I have a very healthy TAIL-TWISTER rotor with control box and lower mast adapter. It's clean and works just fine. (8-9 on 10 scale) It has 100 feet of brand new control cable. It appears to have had very little use and is not weathered a bit. BTW, I set the rotor up on a mast on my patio table and exercised it for several days with a 70 lb top load. It preformed flawlessly. I purchased the Tail-Twister for use on my Texas Towers MA-40 with the (MARB-40) base rotor mount and then decided not to do the Steppir system as dipole reception has been exceptional from my "Tall Pine" site here in Virginia Beach.
Item: $650 + shipping For Sale is one of my two Tentec Pegasus software controlled radios with the yearly PM, TX/RX alignment just preformed by Tentec in January 2008. This radio is in excellent condition; it is clean and has always been used in a non smoking environment. The Pegasus radio is controlled from your desktop PC with the use of software from Tentec or N4PY. Specs: 100 KHz to 30 MHz, 100 Watts out, SSB, AM, FM and CW. If you would like to listen to this radio over the Internet please follow the link below, choose the ON AIR button, select the Broad Band Stream and enjoy! Any questions or concerns please Email or give me a call on my Cell (757) 651-1316. PayPal is accepted - Please call me for details.
In excellent operational condition I offer my Heathkit SB-200 Linear Amplifier. 80 - 40 - 20 - 15 - and 10 meters This unit is in Excellent Condition. Wired for 120 Volt AC operation but can easily be re-configured for 240 Volts. I am selling this item from my collection of gear used in my shack. This AMP is excess to my needs. I have used this SB-200 very little for the past 16 months with no issues. This unit is in above average condition. There are no scratches of conquience on the panel or case. As you can see from the photos, the workmanship is excellent. Since I have been using this unit for the past 16 months the SB-200 is used, it works, and is being sold AS IS, NO ISSUES, NO RETURNS, NO DOA's .. This unit is heavy. It weighs 35 pounds before packaging. It will probably weigh about 40 lbs after it is packed. The unit will be professionally packed by the UPS store. Estimated cost is $50 for packaging. Buyer will pay actual shipping charges from 23464 plus the $50 for packaging. Estimated package size is 24" x 24" x 16". Insurance is reasonable and is required if shipped. Check with UPS for shipping to your zip code so you are not surprised by the shipping charges. If the unit is picked up locally, or if I deliver within 30 miles, there would be no packaging or shipping charges.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
||
|
. |
||
|
|
|
|
|
|
||
|
|
Item: $25 + Shipping New in package MFJ 1675T,75 Meter, 250 watt PEP, HF Mobile Ham-Tenna W/ 3/8-24 stub. Can be used with Diamond K400 mount listed above. A Heavy duty 4 foot, 3/8 inch diameter fiberglass rod, a nearly indestructible .125 inch diameter PH-17-7 stainless steel whip and chrome plated brass fittings will give you years of dependable service.
|
|
|
|
Item: $25 + Shipping New in package WORKMAN 10 Meter,250 watt PEP, HF Mobile Ham-Tenna W/ 3/8-24 stub. Can be used with Diamond K400 mount listed above. HF Mobile antenna W/ 3/8-24 stub. Can be used with Diamond K400 mount listed above.
|
|
|
|
Item: $25 + Shipping New in package WD4BUM model 9110, 10 Meter, 600 watt PEP, HF Mobile Ham Stick antenna W/ 3/8-24 stub. Can be used with Diamond K400 mount listed above. This two-piece MONOBAND ANTENNA consist of a hollow fiberglass base section approximately 1/2 inch diameter with the loading coil wound directly on the fiberglass and covered with PVC shrink tubing. The plated brass base fitting has 3/8 inch X 24 TPI male threads that fit most amateur mobile mounts. And is rated for 600 Watts DC. The top section is a tapered 17-7 PH tempered Stainless Steel whip that telescopes into the base section for frequency adjustment. It is secured by two set screws.
|
|
|
|
||
|
Updated 08 MAY 2008
|
GO TO PAGE 2..... |
